Specifications:
The autoclave must adopt distilled water as an operation medium. Even Purified water has various minerals and can produce furring scale after evaporation at high temperatures, which, after some time, can lead to the leaking of steam due to improper closure. It can also lead to clogging in the narrow pipes and pressure sensor, to the malfunctioning of the temperature sensor, and to other failures. Once the furring scale enters the handpiece and another instrument which are hollow inside or has apertures, It will clog the narrow pipes and axis, lowering the turning speed of the handpiece, thus reducing its life span. Therefore, using distilled water is necessary. However since all the stomatology clinics are located far from each other, It is difficult for them to buy distilled water.
Rated voltage: 220VAC 50Hz 110VAC 60Hz
Rated power: 750W
Distiller water: 1L/H
Chamber size: 180×200
Outside size: 290×290×390 mm
Gross Weight: 6.0kgs
Packing size: 530*330*300mm
Note: Has the function of automatic overtemperature protection. Safe temperature The power supply automatically cuts off when the temperature is higher than 160 ° C.
Plug: There are European standards, American standards, British standards, national standards, and so on need which kind of plug please explain in advance, the default-issued national standard plug! Thank you for your cooperation
Machine trial instructions: After getting the machine, you will find that after plugging it in, you can burn it directly without pressing the button. Please don't be nervous in this situation, it is normal.
The reason is that the button used by the machine is a thermal button, which is different from the button used at home. The thermal button is that once it is pressed, it will jump off only after the temperature reaches a certain value. Each machine is powered to check that it is normal before it is sent out so that the start button of the machine must be pressed.
The thermal sensing limit of this machine should be 160 degrees, that is to say, after the water in the inner tank is dried, once the temperature exceeds 160 degrees, it will automatically cut off. When I checked, I just switched on the power and pulled the plug, so the temperature of the inner tank obviously could not reach 160 degrees, and the thermal button would not jump off.
That's why the first time you burn the machine, you turn on the power switch and you burn it without pressing a button. Simply put, it is that the button has been pressed, and it can be pressed again when it is burned once.
